Human-to-metal electrostatic discharge current measurements – Notes on the ESD current waveform

The Electrostatic Discharge (ESD) phenomenon has been described through the IEC 61000-4-2. ESD current parameters' values, have been set in this Standard. The theoretical ESD current waveform defined in this standard, describing the conventional Contact discharge mode, needs to be re-evaluated on the basis of accurate experimental data. Even though the standard deals with commercial ESD generators, its goal is to simulate the natural phenomenon as good as possible. More and accurate data may contribute to the better simulation of the natural phenomenon. New values and better comprehension of the phenomenon demand new measurements based on high end measuring equipment. Such works and publications have been carried out the past years. Yet, the need to systematize and integrate this work remains. Larger and trust-worthy series of measurements need to be carried out and presented clearly.This paper deals with new ESD-current data, taken with broadband equipment. New and more detailed measurements like these, were never before taken at such a large number of individuals. The goal of this work is that the data acquired can serve as a basis for re-evaluating the conventional approach of the scientific community to the ESD event.In this paper, using a broadband measuring system, new parameters' values are measured and relations are presented, following standard statistical procedures. The results, which occur from measurements carried out on tenths of human individuals, are questioning the Standard in many points. A new way of approaching the standardization of the ESD current is proposed, as the excuse of the poor measuring equipment that sets barriers on the measuring accuracy, does not apply any more. The charging voltages of 500 V and 1000 V were also examined since such range of voltages are often met at ESD events and they are considered very harmful.     

Microstructural stability and age-hardening behavior of Re-added dual two-phase Ni3Al and Ni3V intermetallic alloys

The effect of Re addition on the microstructure and hardening behaviour of the dual two-phase Ni₃Al (L1₂) and Ni₃V (D0₂₂) intermetallic alloy was investigated by scanning electron microscopy, transmission electron microscopy and Vickers hardness test. The two-phase eutectoid microstructure accompanying the Re-rich precipitates were observed in the channel region of the alloys in which Re substituted for Ni but not in those in which Re substituted for Al and V. The concomitant addition of Nb (or Ta) with Re more stabilized the two-phase eutectoid microstructure and consequently more induced the fine precipitates in the channel region. The annealing at temperatures below the eutectoid temperature was necessary to induce the fine precipitates in the channel region and thereby result in the precipitation hardening. The fine precipitation in the channel region and related hardening was attributed to the alloying feature so that Re is soluble in the A1 (fcc) phase at high temperatures and becomes less soluble in the two intermetallic phases decomposed from the A1 phase at low temperatures.     

Gas-phase 21Ne NMR studies and the nuclear magnetic dipole moment of neon-21

Gas-phase ²¹Ne nuclear magnetic resonance spectra were measured at the natural abundance of ²¹Ne isotope for samples consisting of pressurized neon up to 60 bar at room temperature and applying the magnetic field of the strength B₀ = 11.7574 T. It showed that the nuclear magnetic resonance frequency is linearly dependent on the density of gaseous neon. The resonance frequency was extrapolated to the zero-density point, and it permitted the determination of the ²¹Ne nuclear magnetic moment, μ(²¹Ne) = 0.6617774(10) μ_N. The present value of μ(²¹Ne) is not influenced by the bulk magnetic susceptibility of neon and interactions between neon atoms; therefore, it is more precise and reliable than the previous result obtained for μ(²¹Ne).     

温度/应变/扭曲三参量同时测量低成本传感系统

提出了一种利用布喇格光纤光栅反射光作信号源、高频CO2激光脉冲写入的长周期光纤光栅和超周期光纤光栅作传感器实现温度、应变和扭曲同时测量的全光栅型低成本强度解调传感方案.文中利用长周期光纤光栅边缘滤波效应实现了温度、应变和扭曲传感信号的实时解调.实验结果表明，其温度和应变的测量灵敏度分别为－0.211 dB/℃和－0.012 dB/10με；而扭曲率的测量灵敏度为0.4394 dB/(rad·m－1)，是该法写入普通LPFG的4倍以上.     

Simulated annealing with noisy or imprecise energy measurements

The annealing algorithm (Ref. 1) is modified to allow for noisy or imprecise measurements of the energy cost function. This is important when the energy cannot be measured exactly or when it is computationally expensive to do so. Under suitable conditions on the noise/imprecision, it is shown that the modified algorithm exhibits the same convergence in probability to the globally minimum energy states as the annealing algorithm (Ref. 2). Since the annealing algorithm will typically enter and exit the minimum energy states infinitely often with probability one, the minimum energy state visited by the annealing algorithm is usually tracked. The effect of using noisy or imprecise energy measurements on tracking the minimum energy state visited by the modified algorithms is examined.The research reported here has been supported under Contracts AFOSR-85-0227, DAAG-29-84-K-0005, and DAAL-03-86-K-0171 and a Purdue Research Initiation Grant.     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

A novel approach to the acoustic characterisation of porous road surfaces

Porous road surfaces offer an effective means of reducing the generation and propagation of noise from road traffic. However, the porosity of these surfaces can deteriorate over time, leading to a reduction in their noise reducing properties. Efficient methods are therefore required for monitoring this performance. Existing techniques for performing in-situ measurements of acoustic absorption are unsuitable for use within the traffic stream. Static measurements using time domain Maximum Length Sequence (MLS) based techniques have been demonstrated to offer advantages over traditional techniques, presenting the opportunity for measurements under dynamic conditions. This paper describes the design of a system for carrying out dynamic MLS-based measurements. Results are presented which demonstrate that stable dynamic measurements can be carried out at speeds of up to 30 km/h.     

Development of the mechanics of underground and special structures in Kazakhstan over the last 40 years

Some results on underground structures obtained by Kazakh mechanicians are reviewed. The review covers a period of the last forty years. Also results on the mechanics of special objects are discussed.Translated from Prikladnaya Mekhanika, Vol. 40, No. 10, pp. 3–36, October 2004.     

Investigations of low- and high-spin states of <Superscript>132</Superscript>La

The fusion evaporation reaction ¹²²Sn(¹⁴N, 4n)¹³²La was used to populate the high-spin states of ¹³²La at the beam energy of 60 MeV. A new band consisting of mostly E2 transitions has been discovered. This band has the interesting links to the ground state 2^- and the isomeric state 6^-. A new transition of energy 351 keV connecting the low-spin states of the positive-parity band based on the πh _11/2 ⊗ νh _11/2 particle configuration, has been found. This has played a very important role in resolving the existing ambiguities and inconsistencies in the spin assignment of the band head. Received: 12 August 2002 / Accepted: 18 March 2003 / Published online: 7 May 2003     

Optimal entropic uncertainty relation for successive measurements in quantum information theory

We derive an optimal bound on the sum of entropic uncertainties of two or more observables when they are sequentially measured on the same ensemble of systems. This optimal bound is shown to be greater than or equal to the bounds derived in the literature on the sum of entropie uncertainties of two observables which are measured on distinct but identically prepared ensembles of systems. In the case of a two-dimensional Hilbert space, the optimum bound for successive measurements of two-spin components, is seen to be strictly greater than the optimal bound for the case when they are measured on distinct ensembles, except when the spin components are mutually parallel or perpendicular